Table of contents: Front brakes ↓ Rear brakes ↓
System type - Dual-circuit diagonal, with vacuum booster, hydraulic with pressure regulator in the rear hydraulic line and handbrake controlled by cable. Some models are equipped with ABS.
Front brakes
- Type - Disc with single-piston caliper
- Production - Girling or Teves
- Disc diameter - 256.0 mm
- Disc thickness: New - 22.0 mm; Wear limit - 20.0 mm
- Minimum disc thickness after restoration - 20.5 mm
- Maximum disc runout - 0.06 mm
- Minimum brake disc pad thickness - 7.0 mm
Rear brakes
Type - Drum with brake, pads, or disc with single-piston caliper
Drum brakes:
- Drum diameter: New - 230.0 mm; Wear limit - 231.0 mm
- Maximum drum diameter after restoration - 230.5 mm
- Maximum radial runout of the drum is 0.1 mm
- Max. lateral runout of the contact surface with the wheel - 0.2 mm
- Minimum brake shoe lining thickness: 2.5 mm
- The diameter of the piston of the working brake cylinder is 17.46 mm
Disc brakes:
- Production - Girling or Teves
- Disc diameter - 245.0 mm
- Disc thickness: New - 10.0 mm; Wear limit - 8.0 mm
- Minimum disc thickness after restoration is 8.5 mm
- Maximum disc runout - 0.06 mm
- Minimum brake disc pad thickness - 7.0 mm
Brake Fluid Type/Specification - Hydraulic Fluid FMVSS 116 DOT 4
Tightening torques, Nm
- Caliper Guide Pin Bolts (Girling) - 35
- Caliper Guide Pins (Teves) - 25
- Front Suspension Caliper Holder to Suspension Strut - 125
- Rear suspension caliper holder to rear axle - 65
- Rear shield of drum brake to pivot pin (drum brakes) — 30
- Master cylinder to booster - 25
- Amplifier block to bulkhead - 25
- Fastening the pressure regulator spring - 25