Table of contents: Front bumper ↓ Rear bumper ↓
Front bumper
1. If equipped, remove the front fog lights and/or turn signals from the bumper.
2. Pry up the trim strip along the top edge of the bumper below the headlights.
3. Unscrew the screws under the radiator grille that secure the center trim strip and carefully remove it (photo).
4. Guided by Chapter 22, remove the radiator grille and ventilation grille.
5. Unscrew the two upper and one lower bolts on each side (photo) and move the bumper slightly forward.
6. Disconnect the headlight washer hose where present and remove the bumper forward from the side guides.
7. Installation is carried out in reverse order.
Rear bumper
8. From inside the luggage compartment, remove the two bolts on each side, pull the bumper back off the side rails and remove it from the vehicle.
9. Installation is carried out in reverse order.