Remove the protective cover.
Press the wheel hub out of the steering knuckle using a mandrel with a support ring VW295a.
If necessary, press out the inner race of the ball bearing using a hooked puller and support ring VW295a.
To remove the bearing outer race from the steering knuckle, first remove both circlips, then press out the bearing outer race using a mandrel and VW442 support ring.
Assemble the hub in the reverse order of disassembly, taking into account the following:
- put the circlips in place and press the outer ring of the bearing to the stop;
- Press in the wheel hub using a mandrel and support ring VW455. When pressing, the support ring should only be in contact with the end face of the bearing inner ring.
Replace the telescopic pole.
Visitor comments