Table of contents: Removal ↓ Installation ↓
Removal
Disconnect the wire from the negative terminal of the battery.
Remove the brake fluid from the reservoir using a syringe.
Disconnect the pipelines from the hydraulic unit.
Hydraulic distribution block
Remove the relay protective cover.
Disconnect the valve body plug and disconnect the ground jumper from it.
Loosen the hydraulic unit mounting bolt.
Remove the hydraulic unit
Installation
Place the hydraulic unit in place and connect the pipes to the corresponding fittings on the unit.
Tighten the hydraulic unit mounting bolt.
Connect the valve body plug and attach a jumper to it to ground.
Install relay protection.
Connect the wire to the negative terminal of the battery.
Top up the brake fluid in the reservoir to the required level and bleed the brake hydraulic system.
This article was copied from an online resource audimanual.ru