43.1. Flywheel and crankshaft seal installation details 1. Seal holder 3; 2. Holder mounting bolt 1; 3. Front crankshaft oil seal; 4. Oil pan; 5. Pan mounting bolt 4; 6. Engine crankcase; 7. Flywheel; 8. Flywheel mounting bolt, subject to replacement; 9. Intermediate plate; 10. Cover fastening bolt 11, 15 Nm; 11. Rear oil seal cover with oil seal
2. The crankshaft installation details are shown in the illustration.
43.2. Crankshaft installation details 1. Main bearing shell for cylinder block (with a groove); 2. Balance shaft module drive sprocket; 3. Main bearing shell (without groove); 4. Adjusting washers (for bearing No.3); 5. Cover fastening bolt 6, 65 Nm, then tighten to an angle of 90°, subject to replacement; 6. Main bearing cap; 7. Rotor of the CKR sensor; 8. Rotor mounting bolt 7, 10 Nm, then tighten to an angle of 90°, subject to replacement; 9. Needle bearing (only on models with manual transmission); 10. Dowel pin; 11. Crankshaft
3. The details of the connecting rod and piston group are shown in the illustration.
43.3. Connecting rod and piston group parts 1. Cover fastening bolt 2; 2. Connecting rod bearing cap with connecting rod (B) and front side (A) marks; 3. Connecting rod bearing shells; 4. Connecting rod with marks (see point 2); 5. Retaining ring; 6. Piston pin; 7. Piston; 8. Compression rings; 9. Oil scraper ring