Order of execution
1. Where present, remove the cap on the air filter.
2. Remove the air intake hose from the air filter housing and position it in front of the suction device.
3. Remove the carbon filter solenoid valve from the bracket and set aside; hoses and wire remain connected.
4. Naturally aspirated engines: open the four tie-down straps around the filter housing.
5. Lift the filter housing cover - the air hose to the throttle valve on the engine remains connected.
6. Remove the filter insert.
7. Turbo engine: Operate only with a cold turbocharger.
8. Unscrew the heat shield.
9. Remove the thin pipe from the clamps.
10. Loosen the tie on the air hose and remove it.
11. Open the four tie straps around the filter housing.
12. Disconnect the connectors on the front of the temperature sensor (pierce the wire tie), at the final ignition stage and at the fresh air flow meter (under the rubber pad).
13. Remove the filter housing cover.
14. Remove the filter insert.
Removing the air filter housing
Removing the air filter of a six-cylinder engine,
Step 1: Remove the air intake hose (3), remove the cover (4). Then the top part is exposed (2) corps. Bolt «1» only unscrewed to remove the filter housing.
2nd stage: after the clamps are opened (2–5), you can remove the top part of the case, and the liner becomes accessible (6) filter. Numeric «1» the fixing bolt of the air filter housing is indicated here.
1. Remove the air filter insert (see above).
2. Loosen the hexagon bolt at the wheel arch.
3. Remove the mounting pins at the bottom of the filter housing from the rubber nozzles on the body.
4. Remove the body.
Visitor comments