Repair Chevrolet Repair Toyota Repair Honda Repair AvtoVAZ Repair Mercedes-Benz Repair BMW Repair Opel
Home  |  Contacts  |  Sitemap  |    
English Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar
AudiManual.ru
 
 
 
 
 
 
 
 
 
 
  • AUDI 80
  • AUDI 100
  • AUDI A3
  • AUDI A4
  • AUDI A6
  • AUDI A8
  • AUDI Q
  • OTHER
  • ARTICLES
A2 (1999-2005)

Removal and installation the air filter insert (Audi A2)

  • Home
  • Audi
  • A2 (1999-2005)
  • Engine 1.4 l (diesel)
  • Fuel injection system
  • Removal and installation the air filter insert
            0
Table of contents: Removal ↓ Installation ↓

Removal



Unscrew bolts «1» and remove the air filter housing cover from the bracket «arrow». Remove the air…


Unscrew bolts "1" and remove the air filter housing cover from the bracket "arrow". Remove the air filter insert.

Installation



To ensure the air flow meter functions properly, it is important to follow the instructions below and to ensure that the operating procedure is followed.

Instructions. If the air filter insert is heavily soiled or wet, dirt particles or moisture may enter the air flow meter and distort the measured air mass value. This will result in a loss of power, since a smaller fuel injection volume is calculated. Use only the original air filter insert. Hose fittings and hoses of the air boost system must be cleaned of oil and grease before installation. Do not use silicone-containing lubricants during installation. The air filter housing must be clean. Use clamps of the appropriate series to secure all hose connections. When blowing out the air filter housing with compressed air, observe the following rules: to avoid malfunctions, important air-conducting units such as the air flow meter, air duct tubes, etc. must be covered with a clean rag. Disposal instructions must be followed! Check the patency of the drain hose (if available), clean if necessary. The drain must be free. Clean the air filter housing (upper and lower parts) from salt residues, dirt or leaves (vacuum if necessary). Check the air flow meter and air duct hose (side of clean air) for salt, dirt and leaves. Check the air duct from the radiator frame to the air filter housing for dirt and leaves. When installing the air filter insert, keep in mind that it is centered by the mount at the bottom of the air filter housing. Install the upper part of the air filter housing onto the lower part carefully, without applying excessive force. In this case, ensure that the upper part of the air filter housing is installed on the air filter insert without skewing (watch the sealing edges of the air filter insert). Ensure that the air duct hose is securely seated on the G70 air flow meter.


(The original version of the article is posted on the website: «audimanual.ru»)
The article was checked by auto expert Daniil Ushakov
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:
Previous articles
Audi A2: Fuel injection system
Next articles

Air filter parts and components
Fuel injection system relays and sensors
Installation locations of injection parts and units (BHC and ATL…
Installation locations of injection parts and units (AMF engines)
Removal and installation the air flow meter
Suction tube (BHC and AMF engines)
Removal and installation the intake manifold (BHC and AMF…
Suction tube (ATL engines)


Similar articles on other Audi car models:
Air Filter Element — Replacement Audi 80 B3 (1986-1991, petrol)
Air filter assembly — removal and installation Audi 100 C3 (1982-1990, diesel)
Changing engine oil and oil filter Audi A3 Type 8L (1996-2003)
Removal the air filter insert Audi A4 B5 (1994-2001, petrol)
Oil and oil filter change Audi A6 C5 (1997-2004)
Draining water from the fuel filter of a V6 TDI diesel engine Audi A8 D2 (1994-2002)
Removal the air filter insert Audi Q5 Type 8R (2008-2017)
Link to this page in different formats


Visitor comments

No comments yet


How much will 37 + 16 =
       



Audi A2(1999-2005) 
  • General information
  • Introduction to the guide
  • Maintenance
  • Engine 1.4 l (gasoline)
  • Engine repair
  • Lubrication system
  • Cooling system
  • Exhaust system
  • Engine 1.6 l (gasoline)
  • Engine repair
  • Lubrication system
  • Cooling system
  • Exhaust system
  • Engine 1.2 l (diesel)
  • Engine repair
  • Lubrication system
  • Cooling system
  • Injection and turbocharging
  • Engine 1.4 l (diesel)
  • Engine repair
  • Lubrication system
  • Cooling system
  • Turbocharging system
  • Supply system
  • Fuel injection system
  • Exhaust system
  • Transmission
  • Mechanical gearbox 02J
  • Mechanical gearbox 02T
  • Mechanical gearbox 085 DS
  • Chassis
  • Car suspension
  • Steering
  • Brake system
  • Body
  • Exterior
  • Interior
  • Seats
  • Doors, locks and windows
  • Safety system
  • Heating and air conditioning
  • Electrical equipment
  • Power devices
  • Equipment and devices
  • Wipers and washers
  • Lighting and lamps
  • Breakers and switches
  • Electrical circuits
 
AudiManual.ru © 2017-2026 · Mobile version · Feedback · Sitemap: EN BG BY UA RS HR RO PL SK HU · Site search · News and articles
80 B2 · 80 B3 petrol · 80 B3 · 80 B4 · 100 C3 diesel · 100 C3 petrol · 100 C3 · 100 C4 petrol · 100 C4 · A3 Type 8L · A4 B5 petrol · A4 B5 · A4 B6 petrol · A4 B6 · A4 B7 · A4 B8 · A6 C4 · A6 C5 · A6 C5 Allroad · A8 D2 · Q5 Type 8R · Q7 Typ 4L · Audi A2 ·
This site uses cookies 🍪. Click the button to accept this fact.