Table of contents: Removal ↓ Installation ↓
Removal
Disconnect the plug connector of the air mass meter "G70". Open both hose clamps and carefully remove the air mass meter "G70" from the suction hose.
Installation
To ensure the air flow meter functions properly, it is important to follow the instructions below and to ensure that the operating procedure is followed.
Instructions. Replace the sealing ring. If the air filter insert is heavily soiled or wet, dirt particles or moisture may enter the air flow meter and distort the measured air mass value. This will result in a loss of power, since a smaller fuel injection volume is calculated. Use only the original air filter insert. Use silicone-free grease to install the air duct hose. Use clamps of the appropriate series to secure all hose connections. Check the air flow meter and air duct hose (clean air side; for salt, dirt and leaves. Check the air duct leading to the air filter insert for contamination. Clean the air filter housing (upper and lower parts) from salt residues, dirt and leaves (if necessary, wash or vacuum clean).