Table of contents: Removal the air flow meter "G70" ↓ Installation ↓
Removal the air flow meter "G70"
Disconnect connector "1" from the air flow meter "G70". Unlock the turbocharger air hose clamp and disconnect it from the air flow meter "G70". Unscrew both screws of the air flow meter "G70". Carefully remove the air flow meter "G70" from the air filter housing guide.
Installation
For the correct operation of the air flow meter "G70" it is important to follow the following instructions and perform the following work steps. If the filter element is heavily soiled or wet, dirt particles or moisture may settle on the air flow meter "G70" and introduce an error in the measurement of the air mass. This will lead to a loss of engine power, since the electronics will calculate less fuel to inject. It is always necessary to use the original air filter element. When installing the air supply hose, it is necessary to use grease (silicone free). Check the air flow meter and air hose (from the filtered air side) for salt deposits, dirt and leaves. Check the intake duct to the filter element for contamination. If there is contamination, clean the air filter housing (upper and lower parts) from salt, dirt or leaf deposits (vacuum if necessary). Installation in reverse order.
The original article is available on the website AudiManual.ru