2. Unscrew the pressure hydraulic line from the working cylinder. Be careful, the brake fluid will leak out, the fluid should not get on the gearbox. Also remember that after disconnecting the line, you cannot press the clutch pedal.
3. Loosen the mounting screws and pull the cylinder out of the gearbox housing backwards.
4. In case of a slave cylinder with a support ring, lightly lubricate the outer surface of the ring with grease when installing the cylinder.
5. When installing the cylinder, press it back so that the mounting screw can be installed.
6. After completing the installation, remove air from the hydraulic system.
Details of the hydraulic clutch drive with a slave cylinder: 1 - brake fluid reservoir, 2 - hose, 3 - pipe, 4 - bearing bracket, 5 - clutch pedal, 6 - Allen screw, 7 - bolt, 8 - primary cylinder, 9 - seal, 10 - locking bracket, 11 - gearbox, 12 - slave cylinder, 13 - air valve, 14 - locking bracket, 15 - holder, 16 - Allen screw, 17 - Allen head screw, 18 and 19 - seal.