2. For carbureted models, remove the air filter as described in Chapter 4.
3. Disconnect the cable from the accelerator pedal lever.
4. In the engine compartment, remove the clamps, then disconnect the inner cable from the sector on the carburetor and the throttle body (photo).
5. Release the end of the cable from the suspension (photo).
6. Disconnect the cable from the bulkhead and remove it from the engine compartment.
7. Installation is carried out in the reverse order, but make sure that the cable is not twisted.
8. Adjusting the cable on models with automatic transmission is described in Section 7. On manual transmission models, the bracket must be installed in the bezel so that the throttle is fully open when the accelerator pedal is fully depressed. When the pedal is fully released, the internal clearance of the cable should not exceed 1.0 mm. On models with a speed control system, with the throttle valve in the idle position, adjust the control mechanism so that the gap between the sleeve and the limiter plate is 0.1-0.3 mm.
The original article is located on the online resource: AUDImanual