Table of contents: Safety beam ↓ Removal and installation the safety… ↓ Removal and installation the left… ↓ Removal and installation the right… ↓
Safety beam
1. Safety beam.
2. Low-frequency sound signal "H7".
3. Spacer bracket, right: bumper trim.
4. Safety bar holder, right.
5. High-frequency sound signal "H2".
6. Bolt: 30 Nm.
7. Spacer bracket, left: bumper trim.
8. Bolt: used for fixing to the radiator frame; 4 Nm.
9. Bolt: 30 Nm.
10. Safety bar holder, left.
11. Bolt: 20 Nm.
12. Nut.
Removal and installation the safety bar
During installation, all cable ties should be placed in their original locations. Remove the trim panel front. bumper. Disconnect plug "4" from the sound signalers and remove wire "3" from the sound signal bracket. Disconnect the washer nozzle hose by cutting the cable ties "1". Loosen the bolts "arrows" and remove the spacer bracket "2" from the bumper trim. Remove the safety beam. "5" from the fastenings. If the timber is safe. it is difficult to remove from the fasteners; you should pry it off with a screwdriver.
Installation in reverse order. Install the front lining. bumpers.
Removal and installation the left safety bar holder
Remove the trim panel front. bumper. Remove the safety bar. Remove the system injector. headlight cleaning. To reinstall, mark the installation. position of the bracket relative to the radiator frame. Unscrew the "arrow" bolts. Unscrew the fixing bolt "1". Tilt the bracket "2" of the safety bar. from the radiator frame outward and remove it.
Installation
Installation in reverse order. Screw the safety beam bracket. in accordance with the mark applied after removal. Install the system injector. headlight cleaning. Install safety beam. Install front cladding. bumpers.
Removal and installation the right safety bar holder
Remove the trim panel front. bumpers. Remove the safety bar. For reinstallation, mark the mounting. position of the bracket relative to the radiator frame. Unscrew the "arrow" bolts. Unscrew the fixing bolt "1". Remove the safety bar holder "2". from the radiator frame.
Installation
Installation in reverse order. Screw the safety beam bracket. in accordance with the mark applied after removal. Install safety beam. Install front cladding. bumpers.
This article was copied from an online resource AUDImanual