Cylinder block from the gearbox side — driven disk (Audi A4 B8)

Slave disk

1. Bolt: replace; 60 Nm + turn further by 90°.
2. Driven disk: Check the holes for cracks and entry holes.
3. Mounting pin.
4. Crankshaft.
5. Shaft seal: for crankshaft on gearbox side.
6. Engine speed sensor ring gear "G28".

The full version is posted on the resource: AUDIMANUAL

The article was checked by auto expert Timur Bazhenov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A4 B8: Diesel engines 3.0 l

Cylinder block on the pulley side — lip seal and sealing flange…
Cylinder block from the belt pulley side — poly V-drive
3.0L Diesel Engine — Powertrain Support
3.0L Diesel Engine — Installation

Cylinder block — crankshaft
Cylinder block — pistons and connecting rods
Chain Drive — Timing Chain Covers
Camshaft chain drive

Similar articles on other Audi car models:
Technical characteristics of the cylinder block Audi 80 B2 (1979-1986)
Cylinder block/crankcase — cleaning and inspection Audi 100 C3 (1982-1990, diesel)
Visual inspection of the gearbox for leaks Audi A3 Type 8L (1996-2003)
Cylinder block Audi A6 C4 (1994-1997)
Visual inspection of gearbox tightness Audi A8 D2 (1994-2002)
Cylinder block from the gearbox side Audi Q5 Type 8R (2008-2017)
Removal and installation the sealing shaft from the gearbox side Audi A2 (1999-2005)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

A4(B8, 2007-2015)

A4(B7, 2004-2008)

A4(B6, 2000-2006)

A4(B6, 2000-2006, petrol)

A4(B5, 1994-2001)

A4(B5, 1994-2001, petrol)