2. Before adjusting, make sure that there is no air in the brake hydraulic system, the brake system is functioning normally, and all parking brake drive components are installed.
3. Adjust the position of the lever on the calipers using feeler gauges so that the distance (And in the illustration) was 1.5 mm. Press the brake pedal hard several times.
5.3. Position of the lever on the caliper
4. Press the lock button (2 in illustration 4.10). Both spring-loaded hooks should hold the loops on the cable. Release the lock button and pull the lever hard at least three times.
5. Press the lock button again (2 in illustration 4.10). Both spring-loaded hooks should hold the loops on the cable. Release the lock button and remove the feeler gauge from the calipers.
6. Check the position of the levers on the caliper again. The distance between the lever stop and the caliper should be from 0 to 1.5 mm.
[The original article is posted on the resource: audimanual.ru]