Withdrawal
1. Open the tailgate and remove the light bulb (1), refer to Section Removal and installation of plafonds of internal illumination.
2. Open the lid in the cladding (3), release the holder and remove the warning sign.
3. Remove 4 screws (2).
4. Remove the top trim on the right and left from the clamp holder using pull hook 3370 or HAZET 2520-1).
5. Carefully remove the 6 spring clips (4) from the tailgate and remove the lining (3).
Installation
1. Installation is carried out in the reverse order of removal. At the same time, make sure that the lining correctly enters the cover at the tailgate lock.
Rear window trim
Withdrawal
1. Open the tailgate and remove the tailgate bottom trim.
2. Remove 2 screws (1).
3. Disconnect 2 spring clips (3) from the sides of the tailgate. (4) - rubber stop.
4. Take out 4 spring clips (3) at the top of the door and remove the lining (2).
Installation
1. Keep the eight rubber stops in the correct position.
2. Install the cladding first on the sides and then on top.
3. Fix facing at first above in apertures of a door of a back, then on each side.
4. Fix the cladding with two screws.
Visitor comments