Withdrawal
Paint mark the position of the front wheels in relation to the hubs. This is necessary to reinstall the wheels in their original position, as a result of which their balance is maintained. With the vehicle on wheels, loosen the front wheel bolts, then raise the vehicle, unscrew the bolts and remove the front wheels.
Release clamping pins 6 (pic. 12.11) and take them out.
Remove bolts 2 (pic. 12.11) using a T25 screwdriver.
Remove the front wheel well trim from under the wing arch.
Installation
Install the front wheel housing trim under the front fender arch and secure with bolts.
Insert clamp pins.
Apply a thin layer of grease to the shoulder of the hub that centers the wheel disc. Install the wheel according to the previously marked marks and secure it with bolts. Lower the vehicle and tighten the wheel bolts to 120 Nm.
Visitor comments