Table of contents: Removal ↓ Installation ↓
Removal
Mark the position of the rear wheels in relation to the hubs with paint. This is necessary to reinstall the wheels in their original position, as a result of which their balance is maintained. With the car standing on its wheels, loosen the rear wheel mounting bolts, then lift the car, unscrew the bolts and remove the rear wheels.
Remove bolts 2 (fig. 12.12) and cap nut 4.
Remove the rear wheel well trim from under the wing arch.
Installation
Apply a thin layer of grease to the flange of the hub that centers the wheel disk. In accordance with the previously applied marks, install the wheel and secure it with bolts. Lower the car and tighten the wheel mounting bolts to a torque of 120 Nm.