Keihin-I carburetor
Carburetor Keihin II
Screw the drive with 10 mm gap -a- in the clamp -1- on the holder.
Insert choke actuator -II- into clip -III-.
Push the choke lever in the direction of the arrow until it stops, the choke is fully open. Clamping bolt -III- is fully tightened in this position.
Check that the choke actuator on the carburetor moves all the way to the stop.
Pull out the choke actuator on the front panel completely. The air damper should open completely.
With the throttle valve fully open, there must be a small air gap -b- between the throttle lever and the throttle lever stops.
Visitor comments