Secure the removed brake caliper so that its weight does not press on the brake hose or brake line and does not damage them. When the brake caliper is removed, do not press the brake pedal. Unscrew the bolt "1" and remove the rear speed sensor "2". Remove the coil spring.
Mark the installation position of the adjusting bolt "1" in relation to the hub bearing housing "2". Unscrew the nut "4" and remove the adjusting washer "3". Remove the adjusting bolt.
Unscrew bolt "4".
Unscrew the bolt "arrow", remove the sealing washer between the hub bearing housing and the shock absorber.
Unscrew nut "3". Remove bolt "1" and remove spacer tube "2". Remove hub bearing housing.
Installation
Installation in reverse order. In this case, it is necessary to take into account the tightening torques. Silent blocks have a limited working torsion range. Therefore, the bolted connections of the wheel suspension should be tightened only when the car is in the unloaded position or the standard suspension position. Raise the wheel support to the unloaded position for cars with steel springs. Insert the hub bearing housing. Insert bolt "1" with spacer tube "2" and screw on nut "3". It is prohibited to use nut "3" to tighten the threaded connection.
Tighten bolt "1". Install the coil spring. Install the brake caliper and brake disc. Install the steering rod. Install the upper wishbone. Install the lower wishbone. Install the rear speed sensor. Install the rear wheel. It is necessary to adjust the wheel alignment angles.