Removal and installation the timing belt (6-cylinder) (Audi A4 B6)

Timing Belt for Camshaft Drive. 2.5L Diesel Engine

1 — Crankshaft timing belt wheel. Can only be installed in one position. Avoid getting oil on the adjacent wheel/crankshaft surface
2 — Timing belt tensioner
3 - Bolt, 10 Nm
4 - Screw, 42 Nm
5 — Tensioner lever. Place washer 7
6 - Screw, 42 Nm
7 — Tensioner lever washer
8 — Tension roller. Place washer 20
9 - Flange bolt, 75 Nm
10 — Camshaft wheel. For intake camshaft
11 — Toothed belt
12 - Bolt, 10 Nm
13 — Coolant pump
14 - Bolt, 10 Nm
15 — Rear right timing belt cover
16 - Rear center timing belt cover
17 — Rear left timing belt cover
18 — Sealing gasket. Be sure to replace
19 — Intake camshaft wheel
20 — Tension roller washer
21 — Flange bolt, 75 Nm
22 — Guide roller
23 — Lower timing belt cover
24 - Bolt, 10 Nm
25 - Screw, 45 Nm
26 — Spacer sleeve
27 - Bolt, 200 Nm + 180°

1 - Fan holder with viscous coupling
2 - Nut, 36 Nm
3 - Screw, 22 Nm
4 — Damper of torsional vibrations of the fuel injection pump wheel
5 — Toothed belt of the fuel injection pump
6 — Fuel injection pump
7 — Fuel injection pump wheel with a thrust flange on one or both sides. When installing, install in the center of the grooves. After installation, check the start of injection and adjust (work of the service station)
8 — Washer
9 - Screw, 22 Nm
10 — Tension roller. For the fuel injection pump drive toothed belt