Front door handle
- 1 - Door handle support
- 2 - Door lock
- 3 - Drive rod
- 4 - Bolt, 20Nm
- 5 - Lock cylinder cover
- 6 - Lock cylinder
- 7 - Door handle
- 8 - Drive lever
- 9 - Clip holder
- 10 - Gate valve
- 11 - door handle
Removal and installation of the front and rear door handles are not fundamentally different.
Withdrawal
1. Remove the door upholstery, refer to Sections Removal and installation of facing of a forward door And Removal and installation of facing of a back door.
2. Remove the door frame with power window from the door, refer to Sections Removal and installation of a frame of a window of a forward door And Removal and installation of a power window.
3. Pull out the drive rod (3) from clamp holder (9).
4. Insert a screwdriver from the inside through the door panel, tilt in the direction of the arrow and release the latch (10) at the door handle (11).
5. Disconnect the door handle from the support and remove it from the door.
Installation
1. Replace the door handle and fix it in the support.
2. Connect the drive rod (3) with clamp (9), tilt the clamp 90°and lock onto the drive rod.
3. Establish an upholstery of a door, address to the corresponding Section.
Visitor comments