Front door exterior handle and lock installation diagram (Audi Q5-8R)

Table of contents: Parts and units of the door lock… ↓ Removal the lock cylinder ↓ Installation ↓ Remove the lock cylinder cap ↓ Installation ↓

Installation diagram of the external door handle and lock 1. External door handle; 2. Bolt 2.5 Nm; 3. Front lining; 4. Bottom lining; 5. Front passenger door housing instead of the lock cylinder; 6. Bolt; 7. Cover. Disconnect from the outer door handle; 8. Door lock; 9. Bolt. 3.5 Nm; 10. Door lock trim panel; 11. Pen body; 12. Door lock control rod; 13. Lock cylinder (for driver's door only); 14. Cover. Driver's side: for cylinder cylinder; front passenger side: closed design; 15. Magnet (only for vehicles with "keyless entry system"); 16. Outside door handle strip (for vehicles without "keyless entry system"); 17. Removing the front door outer handle sensor "G605" / "G606" for cars with "keyless entry system"

Parts and units of the door lock cylinder body

I 1. Lid; 2. Magnet (only for vehicles with "keyless entry system"); 3. Lock cylinder. Unlock the trim on the front side of the door. Unscrew the clamp bolt completely with a screwdriver. Press the fastening bracket with a screwdriver and remove the lock cylinder with the cap on the side; 4. Mounting bracket. Spare parts are not included in the scope of supply of the bearing cage; 5. Overlay

Removal the lock cylinder

Move the door seal to the side and remove the trim above the hole "arrow A". Unscrew the clamping bolt "4" completely with a screwdriver. Press the locking pin "3" of the lock cylinder inward. Remove the lock cylinder "2" from the support bracket -

arrow B-.

If the lock cylinder cannot be removed, insert the ignition key into the lock cylinder and remove it by turning the key slightly.

If the lock cylinder cannot be removed, insert the ignition key into the lock cylinder and remove…

Installation

Insert the lock cylinder into the support bracket, and then make sure that the door lock opens and closes.

Remove the lock cylinder cap

Remove the lock cylinder. Release the fastening brackets "arrows" and remove the cap "2" from the lock cylinder "1", if necessary, use a small screwdriver.