Removal the front door inner handle drive cable (Audi Q5-8R)

Table of contents: Removal the inner door handle drive… ↓ Installation ↓

Removal the inner door handle drive cable

Remove the lock cylinder. Remove the door trim. Remove the door trim. Remove the door lock trim. Unscrew the "arrow" bolts.

Press door lock "1" to the side and, if necessary, disconnect plug connector "2". Disconnect drive cable "3" on door lock cable support "2" "arrow A".

Turn nipple "1" 90° in the direction of arrow "B" and remove it from the door handle release lever "4".

Turn nipple «1» 90° in the direction of arrow «B» and remove it from the door handle release lever…

Installation

Insert nipple "2" into the release lever "3" of the door handle "lower arrow". Turn the nipple 90° -upper arrow- and press the drive cable into the door lock cable support "1" until it locks audibly.

Install door lock trim. Install door cover. Install door trim. Install lock cylinder.

[Read the original source on the website «AUDIMANUAL»]

The article was checked by auto expert Timur Bazhenov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi Q Q5 Type 8R: Doors, locks and windows

Removal the front door lock drive cable
Front door lock and mounting bracket
Front door exterior handle
Front door exterior handle and lock installation diagram

Central lock repair
Removal the front door control unit
Removal the fuel tank flap opening motor
Fuel tank flap emergency release element