Table of contents: Removal ↓ Installation ↓
- 1 - Wing
- 2 — Bolt*,7 Nm
- 3 — Bolt*, 10 Nm
- 4 — Bolt*, 10 Nm
- 5 — Bolt*, 10 Nm
- 6 — Bolt*, 10 Nm
- 7 — Bracket
- 8 — Bolt*,10 Nm
*) replace after each unscrewing
Removal
1. Disconnect the negative (-) battery cable.
Warning: Follow the instructions in Section Replacing the battery.
2. Remove the bumper, refer to Section Removal and installation the front bumper.
3. Remove the wing liner, refer to Section Removal and installation the front wing liner.
4. Unscrew the bolt (1) from the nut (3) and remove the lock (2) from the wing (4).
5. Remove the headlight mounting screws, refer to Section Removal and installation headlights.
6. Disconnect the side turn signal repeater connector.
7. Remove bolts (2) to (6) and (8) and remove wing (1), refer to the illustration at the beginning of the section.
Installation
1. Installation is performed in the reverse order of removal. In this case, the wing mounting bolts and washers must be replaced with new ones.
2. Connect the negative (-) battery cable.
Warning: Follow the instructions in Section Replacing the battery.
(Content source: the specified website AudiManual.ru)