Table of contents: Removal ↓ Installation ↓
Fig. 16–8. Front fender: 1, 3, 4, 5 – bolts, 9.5 N·m; 2 – plate; 6 – front wing
The front wing and its fastening elements are shown in Fig. 16–8.
Removal
Take it off front bumper.
Loosen the screws and remove the front wheel well trim.
Remove the side turn signal repeater.
Unscrew the front fender mounting bolts 1, 3, 4 and 5 (Fig. 16–8). To avoid damaging the paintwork, tape the areas around the fender mounting screws.
Remove the wing from the car.
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
Install the front fender on the vehicle, align the bolt holes and tighten the bolts to 9.5 N·m. When installing the fender, check that the gaps between the fender and the hood, as well as between the fender and the front door, are uniform along the entire length and are 3.5 mm.
The article was copied from the website: AUDImanual