Table of contents: Removal ↓ Installation ↓
- 1 — Hood release cable
- 2 — Drive lever
- 3 - Bolt
- 4 — Locking bracket
- 5 — Hood lock
- 6 - Clamp holders
Removal
1. Remove the pocket from the driver's side, refer to Section Removal and installation the pocket on the driver's side.
2. Remove the front fender liner, refer to Section Removal and installation the front wing liner.
3. Pull the hood release lever (2). Remove the screw (3) and disconnect the cable (1) from the lever.
4. Open the hood and detach the bracket (4) from the support.
5. Pull the cable (1) out of the support at the bonnet lock (5) and disconnect the ball at the cable from the eye (arrow A).
6. Disconnect the cable at the clamp holders (6) and pull it out through the guide channel in the engine compartment.
Installation
1. Installation is performed in the reverse order of removal.