Warning: Follow the instructions in Section Replacing the battery.
2. Fully lower the window and open the door.
3. Remove facing of a door, address to the corresponding Section.
4. Disconnect the connector and pull the wires out of the door.
5. Press the cable cover out of the door (1).
6. Ask an assistant to hold the door. Loosen the door hinge screws (2) below and above.
Warning: The illustration shows the bottom hinge of the front door.
7. Remove the door and place it on a soft base.
Installation
1. Replace the door with the help of an assistant and screw in the hinge fixing screws without tightening them.
2. Loosen the door lock latch, close the door and check the gap along the contour of the door fit. If necessary, adjust the door, refer to the relevant Section.
3. Tighten the hinge fixing screws to the torque 32Nm.
4. Further installation is carried out in the reverse order of removal.
5. Connect the negative cable (-) battery.
Warning: Follow the instructions in Section Replacing the battery.
Visitor comments