1. To transfer the lock bracket to the service position, remove the engine covers 2 and 3. Unscrew on the bracket and remove the air duct, which is located between the bracket and the air filter.
Lock bracket in service position: 1 - lock bracket, 2 - left engine cover, 3 - right engine cover, 4 - screw with washer (10 Nm), 5 - screw washer (50 Nm).
2. Screw special tool 3369 into the holes on the right and left sides.
Screwing in special tool 3369
3. Remove fixing screws 4 and pull the lock bracket forward until the rear hole on the bracket matches the front threaded hole in the fender bracket.
4. Fasten the lock bracket by screwing it on the left and right.
Fixing the lock bracket
5. After bringing the lock bracket to its normal position, it is necessary to check the headlight adjustment, they may need to be adjusted.
Visitor comments