Front fender: 1 - wing, 2 - screw with washer (7 Nm), 3, 4, 5, 6 and 8 - screws with washer (10 Nm), 7 - holder
1. Remove the bumper and wheel guard. Remove the closing piece (see the following work steps). Loosen the headlight and disconnect the connectors for the side turn signal. Loosen all screws at positions 2-6.
2. To dismantle the locking piece, the front wheel and wheel guard must be removed. Remove screws 1 from spacer clips 3 and pull end piece 2 out of wing 4 Installation tightening torque: 2 Nm.
Dismantling the closing part: 1 - screws, 2 - closing piece, 3 - expansion clamp, 4 - wing
3. Installation is carried out in the reverse order.
Visitor comments