Withdrawal
1. Disconnect the wiring from the air flow sensor (DMRV) on the air filter cover. Disconnect the small hose as well.
2. Release the wiring and hose from the fasteners on the air filter cover.
3. Loosen the clamp and disconnect the air duct from the air filter cover.
4. Unhook the spring clips and remove the air filter cover, remove its sweeping element, as described in chapter 1A. The sensor is fragile and requires delicate handling.
5. Turn away a bolt of fastening and remove the air filter (pic. 2.5).
6. To remove the remaining air ducts, tighten the handbrake, raise the front of the car and place it on the safety supports. Remove the protective casing installed under the radiator.
7. Loosen the clamps and disconnect the U-hose from the intercooler and air pipe in the left side of the engine compartment.
8. Loosen the clamp and disconnect the air filter hose to the right of the air pipe, then remove the pipe.
9. Loosen the clamps and disconnect the rear air ducts from the intercooler and intake manifold. Disconnect the wiring and hoses, unscrew the fastening bolts and remove the air ducts.
Installation
10. Installation - reverse procedure.
Visitor comments