Table of contents: Examination ↓ Adjustment ↓
A basic adjustment should be made after each brake pad replacement.
Raise the car.
Release the handbrake.
Examination

Press the handbrake cable lever all the way down with a screwdriver. If the opposite caliper lever is pulled back all the way, the handbrake cable is too tight.

Note: The brake caliper is shown removed in the lower picture only to better illustrate the stop.
Adjustment

Loosen the handbrake cable adjusting nut until both levers touch the stops.
Insert a screwdriver with a diameter of at least 6 mm between the rear end of the brake force regulator spring and the roller.
press the brake pedal 40 times with the engine not running.
Note: Starting from 1.86 (Nb 89JA221810 or 89JA25957) a brake caliper with a piston diameter of 38 mm is installed (previously 36 mm). The distinguishing feature is the number "38" stamped on the caliper. For cars with a piston diameter of 38 mm, press the brake pedal once to install.

Finally, check whether both wheels turn freely
Remove the screwdriver.
(The original publication in its entirety is posted on the website «AudiManual»)
