2. Loosen the screw and remove the brake disc from the hub.
3. Remove the screws and take out the mudguard.
4. Support the wheel bearing housing, hub down (photo), and press or tap out the hub. The inner race of the bearing will remain on the hub and therefore the bearing cannot be reused. Use an extractor to remove the inner race from the hub.
5. Remove the retaining rings, then support the wheel bearing housing and press or knock out the bearing.
6. Clean the hub and the recess in the wheel bearing housing.
7. Install the outer snap ring, then support the wheel bearing housing and tap the new bearing using a metal pipe on the outer ring only. Install the inner snap ring.
8. Place the hub with the bearing shoulder facing up, then insert the bearing and housing using a metal pipe on the inner race only.
9. Install the mudguard and brake disc, tighten the disc screw, then install the front suspension strut, following the Chapter 3.