Install the car on a lift. Remove the wheels. Do not damage the stabilizer paint when removing and installing. Depending on the engine type, remove the rear muffler of the exhaust system. Unscrew bolt "4" on the left and right. Stabilizer "4" is removed and installed complete with rubber supports "1" and clamps "3". Do not remove the clamps and rubber supports. Unscrew bolts "2" on the left and right and remove stabilizer "4" with connecting rods.
Unscrew and remove the connecting rod from the stabilizer.
Installation
Installation in the reverse order. In this case, it is necessary to take into account the tightening torques. Silent blocks have a limited working torsion range. Therefore, the bolted connections of the wheel suspension should be tightened only when the car is in the unloaded position or in the standard suspension position. Raise the wheel support with the suspension in a static position on a car with coil springs. Install the connecting rod on the stabilizer and tighten the bolted connection by hand. Install the stabilizer and slightly tighten bolts "4" on the right and left. First, bait bolts "2" on the left and right. Then evenly tighten bolts "2" on the left and right. Tighten bolt "1" and nut "3" on the left and right. Tighten bolt "4" on the left and right. It is necessary to adjust the wheel alignment angles. Tighten the wheel.
The original material is located on the website: AudiManual