Table of contents: Removal ↓ Installation ↓
Removal
1. Drain the coolant.
2. Remove the accessory drive V-belt (see the relevant chapter).
3. Remove the power steering pump pulley mounting bolts, holding the pulley from turning with a trunnion wrench, such as the wrench with part number 3212 (see illustration).
8.3. Unscrew the power steering pump pulley mounting bolts, holding the pulley from turning with a 3212 trunnion wrench
4. Disconnect the power steering pump from the bracket without disconnecting the hoses from it, and move the pump away from the work area.
5. Unscrew the bolt (see arrow in illustration) fastening the holder to the oil pan and move it towards the air conditioning pipeline.
8.5. Unscrew the bolt (see arrow) fasten the holder to the oil pan and move it towards the air conditioning pipeline
Warning! Do not open the refrigerant circulation system yourself - risk of frostbite! All work related to the air conditioner should be entrusted to a specialized workshop.
6. Disconnect plug 1 of the air conditioning compressor pressure reducing valve, unscrew the bolts securing the compressor to the bracket (see arrows in the illustration).
8.6. Disconnect plug 1 of the air conditioning compressor pressure reducing valve, unscrew the compressor mounting bolts to the bracket (see arrows)
7. Tie the air conditioning compressor to the subframe with wire without disconnecting the pipes from it (see arrow in illustration).
8.7. Tie the air conditioning compressor to the subframe with wire without disconnecting the pipes from it (see arrow)
8. Unscrew the bolts (see arrows in the illustration) and remove the air conditioning compressor bracket.
8.8. Unscrew the bolts (see arrows) and remove the air conditioning compressor bracket
9. Loosen the oil cooler hose clamps (see arrows in the illustration) and slide them onto the hoses.
8.9. Loosen the clamps securing the oil cooler hoses (see arrows) and move them onto the hoses
10. Place a container under the engine to collect any leaking oil and coolant.
11. Disconnect the rear hose from the oil cooler.
12. Unscrew bolts 1-4 and remove the oil cooler and power steering pump bracket (see illustration 8.9).
Installation
Installation of the oil pump bracket and power steering pump is carried out in the reverse order of removal.
(The original article is posted on the resource: AUDIMANUAL)