Shaft sealing cuffs for gearboxes
The sealing rings for shafts "A" and "B" are replaced only with the gearbox removed. The sealing rings for shafts "C", "D", and "E" are replaced only with the gearbox installed. When replacing the final drive cover "pos. 2", it is necessary to adjust the preload of the differential tapered bearing.
A. Drive shaft sealing ring.
B. Sealing ring for left shaft with flange.
C. Sealing ring for right shaft with flange.
D. Sealing ring of shaft with flange or output shaft of gearbox with toothed rim.
E. Shift shaft sealing ring.
1. Right shaft with flange.
2. Main gear cover.
3. Sealing ring on the main gear cover.
4. Differential.
5. KP.
6. Output shaft of the gearbox: with a toothed ring with a torsional vibration damper; when replacing the gearbox output shaft with a toothed ring, also replace the shaft seal "D".
7. Gearbox output shaft with ring gear: without torsional vibration damper; when replacing the gearbox output shaft with a toothed ring, also replace the shaft seal "D".
8. Dust ring: Replace after dismantling.
9. Rear shaft with flange.
10. Left shaft with flange.
11. Clutch module.
12. Bolt: 24 Nm;steel bolts (M8; length 38 mm), 10 pcs.
(This article was copied from an online resource audimanual.ru)