Table of contents: Washer reservoir, washer tubes,… ↓ Removal and installation of the… ↓ Removal and installation the injector ↓
Washer reservoir, washer tubes, nozzle
1. Washer reservoir.
2. Rear wiper motor. glass "V12".
3. Windscreen wiper arm.
4. Nozzle.
5. Rear washer pipe. glass.
6. Mounting ring: for windshield washer pump "V5".
7. Windshield washer pump "V5".
8. Sealing sleeve.
Removal and installation of the washer fluid pump "V5"
Turn off the ignition. Remove the front left wheel. Remove the front left fender liner. Disconnect plug connection "5". Place a collecting container under the washer reservoir. Unlock the safety clips "3" in the "direction of the arrow" and disconnect the washer pipes "1" and "2" from the windshield washer pump. Remove the windshield washer pump "V5" "pos. 4" upwards from the windshield washer reservoir.
If the holder for the windshield washer pump "V5" is damaged, then it is necessary to replace the holder. Use a screwdriver to push the damaged holder "1" out of the mount in the windshield washer reservoir "2" to the outside of the Strelka car.
Installation in reverse order. Check the seal. bushing for damage. Install the front left fender liner.
Removal and installation the injector
Carefully open the cap "arrow" and remove.
Carefully remove nozzle "2" from the connecting tube "arrow".
Installation in reverse order: install the nozzle so that the spray hole is directed into the groove on the wiper arm.
The original text is available on the website AudiManual.ru