Withdrawal
1. Remove the protective cap 1 from the rear window wiper lever by carefully prying it out with a screwdriver (see arrow in illustration).
20.1. Remove the protective cap 1 from the rear window wiper lever by carefully prying it out with a screwdriver (see arrow)
2. Carefully remove jet 2 from the axle (see illustration 20.1).
Installation
The rear window washer jet is installed in the reverse order of removal.
Adjustment
3. Use a needle to correct the direction of the jet of washing liquid from the jet. To do this, insert a needle into the jet nozzle and mark the point on the glass where the opposite end of the needle points. In specialized workshops, the T10127 tool is used for this purpose (see illustration).
20.3. Tool T10127 for adjusting the direction of the washer fluid jet
4. Mark with a washable felt-tip pen on the rear window the point where the jet of washing liquid should fall, and adjust the position of the jet so that the jet of liquid hits this point (see illustration).
20.4. Adjust the position of the jet so that the washer fluid hits the point marked on the rear window
Installation dimension: a = 280 mm.
Visitor comments