1. Bracket for built-in door parts
2. Door glass. Loosen the bolts and remove the glass from the support strip. Remove the glass downwards from the guides. Installation: Insert the glass into the guides and press it against the B-pillar gasket. Raise the glass (insert into the door seal) until the latch is fixed in the support bar. Tighten the bolt to a torque of 2.5 + 0.5 Nm. Then lower the glass
3. Support bar
4. Bolt Tough, 3 Nm
5. Hidden rivet. Observe the sequence of riveting. First, connect the window regulator with a rivet in this place
6. Blind rivet
7. Window regulator. Remove the window regulator motor. Remove the bracket of the built-in door parts. Drill out the rivet heads and knock out the pins. It is necessary to remove the pins from the bracket. Installation: When installing, it is necessary to connect the window regulator with rivets in the sequence