1. Rear door. For better clarity, the rear door seal/mounting bracket is not shown in the figure. Seal (sealing strips made of polyurethane foam)rear door/mounting bracket. Seal (butyl skin "AKL 450 005 05") surfaces between the hinge/safety bar. Seal the holes in the safety bar with plugs and sealant
2. Bracket of built-in door parts. To remove, mark the position of the bracket on the door, for example, with a thin felt-tip pen. Remove the mounting bracket. Disconnect the electrical wires from the bracket of built-in door parts and remove them from the fasteners. Loosen the bolts and remove the bracket of built-in door parts upwards. Installation: Before installing the bracket, make sure that the adjusting elements are screwed in completely. If necessary, tighten the adjusting elements by hand. Insert the bracket into the door from above. Lightly tighten the bolts. Close the door. Align the bracket relative to the door opening. Lightly tighten the lower bolts. Open the door. Check the gaps. If necessary, adjust the position of the bracket. If the gaps are the desired size, then during installation, tighten the bolts in this sequence to a torque of 30 Nm. Be sure to follow the sequence of tightening the bolts
3. Adjusting element. When tightening the bolts, the element is adjusted in length. Before installing the bracket of the built-in door parts, it is necessary to fully tighten the adjusting elements (left hand thread)
4. Bolt Torg, 30 Nm. Observe the tightening sequence of the fastening bolts during installation
5-7. Bolt Togh, 30 Nm
Adjusting element
Before installing the bracket of the built-in door parts, it is necessary to screw the threaded bushings "2" of the adjusting element "1" counterclockwise to the end. The locking device "arrow" of the threaded bushing should be between the stop and the rotation stop.