Removal and installation side direction indicators (Audi A4 B6)

1. Removal: Press the turn signal against the direction of travel against the mounting strip (arrow) and carefully remove it from the hole in the wing.

Side direction indicator

2. Disconnect the connector, replace the lamp if necessary.

3. Installation of the side direction indicator is carried out in the reverse order.

The article was checked by auto expert Alexey Ivanov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Audi A4 B6: Lighting and signaling

Replacement of the upper brake light
Replacing license plate light bulbs
Removal and installation the rear light and rear light bulbs
Temporary headlight adjustment

Front lamp and reading light
Rear lamp and reading light
Dismantling and installation of interior lighting fixtures and…
Signaling devices — general information

Similar articles on other Audi car models:
Electrical connection diagram for direction indicators and… Audi 80 B3 (1986-1991, petrol)
Direction indicators and hazard warning lights, side lights and… Audi 100 C3 (1982-1990, petrol)
Removal and installation the pocket on the driver's side Audi A3 Type 8L (1996-2003)
Side body trim Audi A6 C5 (1997-2004)
Tire wear indicators Audi A8 D2 (1994-2002)
Cylinder block from the gearbox side Audi Q5 Type 8R (2008-2017)
Removal and installation the sealing shaft from the gearbox side Audi A2 (1999-2005)

Link to this page in different formats

HTMLTextBB Code

Visitor comments

No comments yet

A4(B8, 2007-2015)

A4(B7, 2004-2008)

A4(B6, 2000-2006)

A4(B6, 2000-2006, petrol)

A4(B5, 1994-2001)

A4(B5, 1994-2001, petrol)