- Folding mirror
- Glove box light
- Front footwell light
- Emergency stop lamp (at the door)
- Footwell rear light
- Tailgate lights
All of these lights use 5W incandescent bulbs. In principle, they are all replaced in approximately the same way. The easiest way to replace the lamp in the folding mirror. To do this, it is enough to carefully remove the lamp from the recess with a screwdriver. Then you need to disconnect the connector. Lamp replacement and installation are carried out in the reverse order. Glove box lights, footwells (front) and trunk, as well as an emergency stop lamp (8 doors) dismantled in the following way.
1. Use a flathead screwdriver to push in the locking lug 1 of the respective luminaire (the figure shows the glove box light) and remove the lamp 2. After that, disconnect the plug connection 3.
Glove box light
2. The incandescent lamp is removed from the reverse side of the corresponding lamp.
3. To install, re-insert the connector plug, insert the luminaire into the hole provided for it, and insert it into the groove.
In order to dismantle rear legroom lamp, do the following:
1. Move the lamp to the outside of the car (arrow) and unfasten it from the opposite side.
Rear footwell lamp
2. Peel off the lid (arrow). On the reverse side of the lantern, remove the incandescent lamp from the socket.
Rear footwell lamp (inside view)
3. Installation is carried out in the reverse order.
Visitor comments