Right rear light A4 (a section has been made for clarity)
Tail light parts and bulbs: 1 - Bulb for rear light (5 W), 2 - Bulb for brake light and rear light (21/5 W), 3 - Two clamps, 4 - Connector, 5 - Retaining part, 6 - Nut (tighten to 12 Nm), 7 - sealing ring round section (in case of damage, replace), 8 - screw (tighten to 6 Nm), 9 - direction indicator bulb (21 W, orange), 10 - reversing light bulb (21 W), 11 - bulb holder, 12 - rear fog light bulb (21 W), 13 - light housing.
1. Removal: Fold forward the cutout 1 of the trunk trim.
2. Remove screw 3.
3. Turn the tail light outward (arrow) and detach the locking pin from the body.
This is important for removing the rear light: 1 - section of the trunk trim that folds forward, 2 - nut (12 Nm), 3 - screw (6 Nm).
4. Disconnect the connector on the lamp holder.
5. Squeeze the retaining clips (arrows) and remove the lamp holder from the rear light.
Lamp holder in the rear light
6. Unscrew the incandescent lamp(s) from the socket.
7. Installation is carried out in the reverse order. Pay attention to the position of the seal between the body and the rear light housing.
8. Place the tail light on the body and press the clips into the holes. Tighten screw 3 to 6 Nm.
9. By loosening nut 2, the rear light can be aligned with the contour of the body in such a way as to ensure uniform gaps.