Side protective pads (Audi A4 B6)

1. It is impossible to dismantle the protective pads without destroying them. To dismantle them, heat the pads with a hair dryer, then remove them from the door.

2. Clean the adhesive surface from dust and grease. Clean the outer sheet with gasoline, treat with silicone solvent and wipe dry.

3. At least two hours before treatment, the car surface temperature must be brought to room temperature. The protective strip must be applied quickly. After removing the film, the strip must be installed within 90 minutes. After that, remove the protective film 3 from the double-sided adhesive tape 4. The application should start from the front.



4. Heat the protective pad to 40°C with a hair dryer, then install it by pressing hard or rolling it.

5. After gluing the pad, the car should stand at room temperature for 4 hours.