2. To install the molding, with the rear door open, insert the molding into the Holder. With the door closed, position the molding according to the cutouts (see picture). Screw in front screw 6.
3. The outer edge of the rear door glass seal should fit snugly against the molding along its entire length. Avoid pressing the seal too tightly, otherwise the protruding edge will cause air flow noise.
Second pillar body molding: 1 - molding, 2 - screws (1.5 Nm), 3 - holder, 4 - clamp, 5 - sleeve, 6 - screws (1.5 Nm), 7 - cover.
4. With the door open, screw in the rear screw 6, press the sleeve 5 into the molding, and put on the cover 7 from below.