Side member lining: 1 - holder for trim, 2 - screw (1 Nm), 3 - screw (2 Nm), 4 - side member trim, 5 - flashing, 6 - rear side member trim, 7 - screw (2 Nm), 8 - screw (1 Nm), 9 - wheel cover.
2. After this, pull the part out of the rear trim in the direction of the arrow and remove it.
3. After dismantling the side member lining, you can remove the holder. To do this, unscrew the screws on the wheel housing. Then unscrew screws 2 and remove holder 1.
4. When installed in the holder/lining of the side member 4, it must engage completely.
5. Screw in screws 3 and 4 (see general view).
Removing the lining holder
6. In order to remove the rear trim of side member 2, it is first necessary to remove the side member trim.
7. Unscrew screws 1 and remove rear trim 2. Designation of remaining parts: 3 - wheel cover, 4 - rear wheel spoiler.
Rear side member trim