Note: For cars with ABS, ready-made original tubes are used, which are not sold by the meter.
Brake hoses provide flexible connections between moving and fixed parts of the vehicle.
Raise the car.
Loosen the union nuts and remove the tube.
Close the line in the direction of the main brake cylinder with a suitable plug or, first, suck out the brake fluid from the reservoir.
If possible, route the new brake pipe in the same place.
If it is necessary to replace the caliper hose, the caliper must first be removed.
Connect the new brake hose without twisting it and tighten it to 10 Nm.
Install only factory approved hoses.
After installation, check with the wheel unloaded (the car is lifted), that the hose follows the entire movement of the wheel without touching anything.
Caution: Protect brake hoses from contact with oils or kerosene, do not paint or cover with underbody protection.
Remove air from the brake system.
Lower the car.