Disconnect the brake hose from the wheel cylinder bleeder.
Loosen the wheel cylinder mounting bolts and remove the cylinder.
Clean parts and check their condition. Replace damaged or worn parts.
Install the wheel cylinder.
Install and tighten cylinder bolts.
Connect the brake hose to the cylinder bleeder port.
Install brake pads and drum.
Bleed hydraulic brakes.
Rear wheel brake: 1 - lock washers of the guide springs of the pads; 2 - brake pads; 3 - lower coupling spring; 4 - parking brake cable; 5 - parking brake drive lever; 6 - tension spring of the device for automatically adjusting the gap between the shoes and the drum; 7 - wedge for automatic clearance adjustment; 8 - upper coupling spring; 9 - expanding bar; 10 - buffer spring.
Visitor comments