Withdrawal
1. Mark with paint the position of the front wheel on the hub. This will allow the assembly to set the balanced wheel in its original position.
2. Loosen the wheel bolts. In this case, the car must be on wheels.
3. Jack up the front of the car, place it on jack stands and, having unscrewed the fastening bolts, remove the front wheel.
4. Pull out the pins of the expanding clamps 6 and remove the clamps (see illustration).
6.4. Front fender:
1 - wing
2 - a screw with a head for a multifaceted socket wrench T25. Tightening torque 1.5 Nm
3 - fender liner
4 - expanding latch
5 - side sill
6 - expanding latch
5. Remove screws 2 with a T25 wrench (see illustration 6.4).
6. Disconnect the fender liner from the wing and remove it.
Installation
The fender liner is installed in the reverse order of removal.
Visitor comments