Lower part of the oil. sump and oil. pump
1. Oil level and temperature sensor "G266".
2. Lip seal: replace.
3. Bolt: replace.
4. Lower part of the oil. pallet.
5. Bolt: replace; 3 Nm + turn further by 90°.
6. Oil separator.
7. Bolt: 9 Nm.
8. Suction pipeline.
9. Bolt: 9 Nm.
10. Sealing ring: replace.
11. Bolt: replace.
12. Oil pump: with brake booster vacuum pump; do not disassemble.
13. Sealing ring: replace.
14. Mounting bushings: 2 pcs.
15. Drive shaft oil. pump.
16. Pressure spring.
17. Leash.
18. Oil sprocket. pump; mounting position: the side with the inscription faces the engine.
19. Bolt: to loosen, hold the sprocket with the pin wrench "3212"; replace; 30 Nm + turn further by +45°; if the bolt cannot be tightened to the correct torque, remove the lower part of the oil. pan and partition and hold the oil drive shaft with an open-end wrench. pump from turning.
20. Bolt: 9 Nm.
21. Oil return pipe.
22. Lip seal: replace.
23. Oil drain plug: 30 Nm.
24. Bolt: 9 Nm.
Lower part of the oil. pallet - last, and tightening torque of bolts
Replace bolts that were tightened with additional tightening.
Replace bolts that were tightened with additional tightening.
| Step | Screws | Tightening torque/rotation angle |
| 1 | "1...15" | 2 Nm |
| 2 | "1...15" | 3 Nm |
| 3 | "1...15" | turn 90° |
Oil pump and vacuum pump - torque and sequence, tightening
Replace bolts that were tightened with additional tightening.
Tighten the bolts in 3 phases in the specified sequence.
| Step | Screws | Tightening torque/rotation angle |
| 1 | "1...3" | screw it in by hand until it stops |
| 2 | "1...3" | 8 Nm |
| 3 | "1...3" | turn 90° |