LED taillights, Avant from model year 2013 (Audi A4 B8)

Table of contents: External rear light installation… ↓ Removal and installation the… ↓ Inner rear light ↓ Removal and installation the rear… ↓

External rear light installation diagram

1. External rear lights.
2. Rear light bulb. running: left rear light lamp. "M16" travel, right rear light bulb. "M17" move; 12 V, 18 W; W16W.
3. Lamp holder.
4. Threaded pin: 3.5 Nm.

Removal and installation the reversing light bulb "M16"/"M17"

Remove the outer rear parking light. Turn lamp holder "1" counterclockwise "arrow" and remove it from the housing. Remove the rear light bulb. stroke from the cartridge.

Installation in reverse order. Insert the new lamp into the socket, being careful not to touch the glass bulb of the lamp with your bare hands. Install the rear. external clearance light.

Inner rear light

1. Inner rear light.
2. Seal: Replace if damaged.
3. Nut: 4 Nm.
4. Clamp bracket: for mounting the rear light. lighting to the trunk door.

Removal and installation the rear interior marker light

Turn off the ignition. Set the light switch to position 0. Remove the trim "1" in the "direction of the arrow".

Disconnect plug connection "1". Unscrew nut "3" and remove clamp bracket "2". Remove the inner section of the rear. lantern to the outside.

Installation

Installation in reverse order. Ensure that the gasket between the body and the rear housing is installed correctly. lamp. Place the clamping bracket "2" on the threaded pin of the rear. inner light and tighten nut "1" 3 turns. Install the inner rear. the light onto the outer contour of the trunk, the clamping bracket should lock into place with a click. Tighten the nut by pressing the back. light to the trunk lid. When tightening the nuts, the clamp bracket is wedged backwards. "arrow" cover.